Gebrauchsanweisung
Instructions for use
Notice d’emploi
Gebruiksaanwijzing
Istruzioni per l’uso
030014 - 4/03 SH325/335
2. FORYOUR SAFETY
GB
• Operating voltage:
- Mains operation: 230 V AC. Ensure that this voltage corresponds to your
mains voltage. Incorrect connection to the power supply may cause
irreparable damage, which is not covered by the guarantee.
- Battery operation : requires 2 x1.5 V DC batteries. Ensure that only LR6
1.5 V AA batteries arer used.
- Mains model (blue): mains mode only
- Dual system model (pink): mains or battery operated.
Important : Do not immerse the appliance, the power lead or the
power supply unit in water.
•The appliance is designed for domestic and personal use only.
•This appliance cannot be used in the shower or the bath.
• Do not leave the appliance for long periods of time at
temperatures below 0° or above 40° (behind a window, in direct sunlight,
for example).
• Do not expose the appliance to direct sunlight, for long periods of time.
• Never use the appliance if it is not working properly or if it has been
dropped (non-visible damage may make the appliance unsafe).
• When the appliance is in use, the clippers must not come into contact
with eyelashes, hair, clothing or any other objects, in order to avoid any
injury risk or jamming. Always keep the appliance out of the reach of
children.
• Do not use the appliance: on your face, on broken or irritated skin, or if
you suffer from dermatological conditions : eczema, varicose veins, skin
inflammation, beauty spots, acne, warts, birth marks, etc.
• Unplug the shaver before cleaning, changing the shaving head or any
other manipulation.
• Never use an electrical extension lead in your bathroom.
•This shaver can be taken to pieces using special tools; to avoid risks,
repair jobs of any kind must be carried out by the manufacturer, the
manufacturer’s after-sales service or any other fully qualified person.
• Should shaver not function correctly, please contact our consumer
service department, your retailer or approved service centre.
• If the power cable is damaged, it must be replaced by the manufacturer,
its after-sales service or a person with similar qualifications to avoid any
danger.
3.TIPS FOR USE
GB
- Mains model (blue): mains mode only
- Dual system model (pink): mains or battery operated.
A- PREPARINGYOUR SKIN
• Before shaving : ensure that your skin is perfectly clean and dry.
• Do not apply cream or moisturising milk.
B- USINGTHE SHAVER
Important : En aucun cas, ce rasoir ne doit être utilisé sous l’eau.
Mains operation
Fit the lead to the shaver. Plug the power supply unit
into an electrical mains socket (230 V). Ensure that the
locking switch (F) is not activated. Otherwise press it
again.
Battery operation
The shaver operates with two LR6 type alkaline
batteries (1.5 V AA).The appliance must be unplugged
from the mains supply before removing the batteries.
To insert and/or replace the batteries, open the
shaver’s casing by pulling the battery cover
downwards (FIG 2). Insert the batteries in the correct
direction, as indicated. Press the locking switch (F)
while turning the On/Off swich On (1).
C- SHAVING
2
3
1) Remove the shaving head’s protective cover.
2)Turn the switch to 1 (on).
3) Start shaving :
• Legs :
- Long hair :
use the clippers first. Hold the appliance slightly tilted
towards you and move it slowly against the lie of the
hair (FIG 3).
- Short hair :
use the microscreen. Hold the appliance at right
angles to the skin and move it slowly against the lie
of the hair (FIG 4).
4
• Underarms and bikini line :
We recommend using the “Sensitive” Micro-screen on both of these
delicate areas.
GB
- Long hair: use the clippers. Hold the appliance slightly tilted towards you
and move it slowly against the lie of the hair.
- Short hair: use the micro-screen. Hold the appliance at right angles to the
skin and move it slowly against the lie of the hair.
To improve efficiency, stretch your skin with your other hand, in order to
raise the hairs. In this way, you will obtain a closer shave, with little or no
irritation.
If your skin becomes irritated, apply a small quantity of talcum powder.
Wait for 24 h before applying perfume or deodorant under your arms.
4)To stop the shaver, turn the switch back to position O (off).The locking
switch will be actived automatically.
5) Unplug the power supply unit after use and replace the protective cover.
4. CLEANING
Important : always clean the appliance’s shaving head after use.
Regular maintenance of the shaving head preserves the shaver’s efficiency
and extends its lifespan.
1) Ensure that your shaver is unplugged.
2) Remove the protective cover.
3) Release the micro-screen support by pressing on the locking clips and
pulling upwards (FIG 5). Carefully remove all hair by blowing on and
beneath the micro-screen. Clean the shaving head also, with the brush.
Never use the brush to clean the micro-screen.
4)The blade unit and trimmer should be lightly oiled from time to time
with sewing machine oil or similar. Put the top part of the shaving head
back into place.
CAUTION ! Do not press against the micro-screen when replacing it.
5) Put the protective cap back in place on the shaving head.
5
6
7
5. PROTECTION OFTHE ENVIRONMENT
At the end of the life of your product, it should go to
a specially-adapted waste recycling centre.
GB
6. INTHE EVENT OF PROBLEMS
• « If your shaver is not giving the best possible results !» :
- Did you remember to hold your skin taut while shaving ?
- Have you cleaned the shaving head properly (see §4) ?
- Have you remembered to oil your shaver ?
- Is your shaver head worn ?You can have it replaced at one of our
approved services centres.
• « Having difficulty getting it to work !» :
- Have you unlocked the lock system ?
- Have you inserted the batteries the right way round (SH335) ?
|