Dyson Vacuum Cleaner DCO3 User Manual

DCO3 Operating manual  
DCO3 Absolute  
DYSON CUSTOMER HELPLINE  
7000 435 7546  
Mon-Fri 9am-6pm, Sat 9am -1pm  
 
Blockages and brushbar  
Unplug your cleaner before carrying out any maintenance.  
Cyclone entry  
duct  
Blockage removal  
cassette catch  
2
4
1
3
1
2
3
4
Using a coin, undo the yellow fastener  
to remove the quick release window.  
Check for blockage at the bottom of the  
duct and underneath the soleplate.  
Remove wand from hose and look  
down the wand to check for daylight.  
Locate blockage removal cassette catch  
at base of hose location.  
Pull back catch, remove cassette and  
check for blockage. To replace, position  
at 450 and click catch back into place.  
Remove Cyclone assembly to check  
Cyclone entry and duct.  
If the brushbar is obstructed, a loud ratchet warning noise will be heard. Pull the cleaner away and it will automatically re-set itself.  
For thread removal, unplug cleaner and carefully cut away threads from brushbar.  
End cap of brushbar  
3
1
2
4
Raised section  
4
If ratchet warning noise continues, stop  
vacuuming, turn off the machine and  
unplug. To free the brushbar, lie the  
2 Using a coin, undo the three yellow  
To replace brushbar, align and locate  
in slots. Rotate until the end caps click  
into place. Rotate brushbar to allow belt  
to centralise, then replace soleplate.  
1
fasteners.  
Remove soleplate and clear the  
3
brushbar obstruction.  
machine on its front to reveal the soleplate.  
 
Bin emptying  
Do not fill bin above maximum line.  
Keep small holes  
clear of dust and fluff.  
2
5 Optional  
1
3
4
Push Cyclone release catch forward to  
free Cyclone assembly.  
Push bin release catch forward to free  
the bin.  
5 To clean bin, wash in warm water.  
Ensure bin inner and seals are  
1
2
3
4
replaced correctly and that the bin is  
completely dry before reassembling.  
Pull Cyclone assembly away from the  
machine.  
Wrap a plastic bag firmly around the  
TM  
rim of the clear bin and empty (wait  
ten seconds to allow dust to settle).  
DYSON CUSTOMER HELPLINE: 7000 435 7546  
Every Dyson vacuum cleaner comes with a 2 year guarantee. If you have a query about  
your Dyson, just call the Dyson Customer Helpline anytime from 9am-6pm Mon-Fri,  
9am-1pm Sat. Most queries can be solved over the telephone by one of our factory-  
trained Helpline staff. If your cleaner needs attention from our engineers, we aim to  
have it repaired, tested and valeted within 3 working days.  
When calling please have the following information ready:  
1. Serial number of your Dyson (between the wheels)  
2. Your postcode  
3. The date of purchase  
4. Where you made your purchase.  
 
Washing your pre-motor filter  
Dyson DCO3 lifetime filters have been developed to give you a vacuum cleaner with lifetime filtration,  
which means no additional running costs. The Dyson lifetime filters are:  
Lifetime HEPA + bacteria-killing screen pre-motor filter  
Lifetime HEPA post-motor filter  
The lifetime pre-motor filter should be washed every 6 months.  
Switch off and unplug cleaner  
before removing the filter.  
Foam core  
1
Rotate twist ring to the left to  
release filter case. Remove filter  
case from machine body. Lift out  
pre-motor filter.  
2
1
2
3
Pull out the foam core inside the  
filter. Only wash foam core.  
Gently rinse the foam core under a  
cold tap until the water runs clear.  
Do not use detergent, washing  
machine or dishwasher.  
Filter cage  
Do not wash the filter cage  
3
4
Squeeze the foam core.  
4
5
Leave the foam core to dry in warm  
place, for example near a radiator  
or in an airing cupboard overnight.  
Do not tumble/spin dry, microwave  
or place in oven or on direct heat.  
Ensure the core is completely dry  
before inserting into filter case.  
Replace filter case and rotate twist  
ring down and to the right to secure.  
6
6
5
NB. The lifetime post-motor filter underneath  
should never need maintenance.  
 
WHEN USING THE DYSON DC03 VACUUM CLEANER  
PLEASE ADHERE TO THESE SIMPLE PRECAUTIONS  
Important safety instructions  
P L E A S E R E A D C A R E F U L L Y B E F O R E U S E  
By doing so you will reduce the risk of fire, electrical shock or injury.  
Check that your supply corresponds to that shown on the rating plate. The  
appliance must only be used as rated, and it should be fitted with an approved  
fuse to BS1362. This appliance is supplied with a moulded three pin mains plug  
for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the  
fuse need to be replaced, please ensure that the replacement fuse has a rating  
of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA  
mark or the BSI mark on the body of the fuse. If the plug contains a removable  
fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose  
the fuse cover, the plug must not be used until a replacement cover is obtained.  
A replacement fuse cover can be purchased from your local Dyson dealer.  
Do not leave the vacuum cleaner plugged into the mains socket outlet.  
Unplug from the outlet when not in use and before cleaning the  
appliance, and before maintenance operations.  
Ensure that hands, feet and fingers, particularly of small children are kept  
away from the cleaner and especially from the brushbar. If hanging the  
cleaner by the storage hook, ensure it is securely fixed and out of the way  
of children and pets. Never allow children to play with or use this appliance.  
Do not use without the bin assembly fitted correctly and both filters in place.  
Only use parts produced or recommended by Dyson (available on the Dyson  
Helpline on 7000 435 7546).  
If the fitted moulded plug is unsuitable for the socket outlet in your home  
then the fuse should be removed and the plug cut off and disposed of  
safely. There is a danger of severe electrical shock if the cut off plug is  
inserted into any 13 amp socket.  
Do not carry out any maintenance work on the cleaner other than  
that outlined in this manual, especially where electrical components are  
concerned.  
If a new plug is to be fitted, please observe the wiring code as shown below. If in  
any doubt please consult a qualified electrician.  
Ensure that the brushbar is off when cleaning smooth floors to avoid  
marking. If carpet pilling occurs, either use the cleaner with brushbar on to  
remove, or contact the carpet retailer.  
IMPORTANT  
Static charges can occur in the clear bin when vacuuming certain carpets.  
These are entirely harmless and are not associated with the mains supply.  
To minimise any effect, do not put your hand or insert any object into the  
clear bin unless you have first emptied and rinsed out the clear bin with  
water. Use a cloth to wipe the shroud.  
The wires in this mains lead are coloured in accordance with the following code:  
BLUE: Neutral  
BROWN: Live  
As the colours of the wire in the mains lead of this appliance may not correspond  
with the coloured markings identifying the terminals in your plug, proceed as  
follows:  
Do not use the cleaner if the cable or plug are damaged or if the machine  
has been damaged, dropped or has come into contact with water or any  
other liquids. In these cases, contact the Dyson Helpline on 7000 435 7546.  
1. The wire which is coloured BLUE must be connected to the terminal in the plug  
which is marked with the letter N or coloured BLACK.  
2. The wire which is coloured BROWN must be connected to the terminal in the  
plug which is marked with the letter L or coloured RED.  
Do not put any part of the body, clothes or any object near or into the  
openings or moving parts of the machine. Do not use the machine with any  
of the openings blocked with an object that may restrict the airflow.  
Under no circumstances should either of these wires be connected to the earth  
terminal of the three pin plug, marked with the letter E or the Earth Symbol  
coloured GREEN or GREEN and YELLOW.  
or  
Do not damage the cable by running the cleaner head over it, closing a door  
on it or running it over sharp edges. Do not put the cable near or on hot  
surfaces. If the cable is damaged, call the Dyson Helpline.  
Always ensure that the cable clamp is fitted and that it clamps the cable outer and  
NOT the coloured wires.  
Always stand above the machine when cleaning on the stairs.  
How to replace the fuse:  
1. Open the fuse compartment with a screwdriver.  
2. Replace the fuse and fuse cover if detachable.  
Do not, under any circumstances, use the cleaner to pick up water or any  
other liquid. Electrical shocks could occur if used outdoors or on wet surfaces.  
If the supply cable of the appliance is damaged, disconnect the appliance from the  
socket outlet immediately; the supply cable must be replaced. This should be carried  
out by Dyson Appliances Ltd only or its appointed agent, as special purpose tools  
and service techniques are required.  
Do not use the cleaner or handle the plug with wet hands.  
Do not use the machine to pick up flammable or combustible substances  
and do not use near such substances. Never pick up asbestos or asbestos  
dust or poisonous solids, such as copier toner.  
Do not use the machine to pick up hot ashes or burning objects of any kind.  
EUROPEAN CONFORMITY INFORMATION  
Do not immerse the whole machine in water for cleaning. The clear bin  
alone may be washed out after emptying. Ensure bin inner and seals are  
replaced correctly and that the cleaner is completely dry before  
reassembling.  
A sample of product has been tested  
and found to be in conformity with  
the following European Directives:  
73/23/EEC Low Voltage (Safety) Directive  
93/68/EEC CE Marking Directive  
89/336/EEC EMC Directive  
Do not use the cleaner near open or gas fires when they are lit.  
UNWANTED PRODUCTS AND THE ENVIRONMENT  
Turn the machine off by the switch button before unplugging from a  
mains outlet.  
Should you find one day that your product needs replacement, or is of no further  
use to you, think of the protection of the environment. Dyson will accept your old  
products and recycle them in an environmentally friendly way.  
When carrying the cleaner, use only the carrying handle positioned  
immediately below the on/off switch.  
 

Continental Fan CE27216 User Manual
Craftsman Air Compressor 91972427 User Manual
Craftsman Lawn Mower 917387203 User Manual
Dyson Vacuum Cleaner DC 07 User Manual
Electro Voice Microphone 633 User Manual
Electro Voice Speaker System FRI+152 94 User Manual
Everpure Water System CG53 20 User Manual
Fellowes Paper Shredder DM65C User Manual
Fisher Price Stroller FP3456 User Manual
Fundex Games Board Games 3 Great Games User Manual