Code Alarm Automobile Alarm CA 310 User Manual

CA 310 Owners Manual  
128-6530  
1 of 10  
 
Whenever the system is triggered, the vehicle's parking lights will flash for the  
full siren sounding period. Optional - whenever the system is triggered, the  
interior courtesy light will flash for the full siren sounding period. Optional-  
whenever the system is armed, the vehicle starter circuit is disabled, and the  
vehicle will not start with the ignition key. Whenever the system is armed, any  
strong impact to the vehicle will cause the shock sensor to trigger the alarm.  
Any lesser impact will cause the pre-detect stage of the shock sensor to emit  
a few short series of warning tones from the siren.  
DISARMING THE SYSTEM:  
As you approach the vehicle, press and release the UNLOCK button on your  
Factory (OEM) transmitter. The parking lights will flash 2 times, the siren will  
chirp 2 times, and the dash mounted LED will turn off.  
NOTE: If the passive arming mode was selected at time of installation, the  
dash mounted LED will start flashing rapidly indicating that the system is  
rearming. Opening any door will suspend the automatic arming.  
If the parking lights flashed 3 times, and the siren chirps 4 times, this  
indicates that the alarm system was triggered during your absence. Before  
turning on the ignition key, examine the dash mounted LED's flash pattern.  
The number of flashes identifies the triggered zone. For additional  
information, refer to INTRUSION WARNING SIGNALS found later in this  
manual.  
INTRUSION WARNING SIGNAL:  
This system will inform you if an intrusion attempt has occurred while you  
were away from the vehicle. Upon disarm, the siren will chirp 4 times and the  
parking lights will flash 3 times. Enter the vehicle and before turning on the  
ignition switch, observe the LED flash pattern.  
If the LED flashes 2 times...pause, 2 times...pause etc., then an intrusion  
attempt was made to open the hood, trunk, or by an accessory triggering  
device. Check the vehicle for indications of forced entry to these openings.  
If the LED flashes 3 times...pause, 3 times...pause etc., then an intrusion  
attempt was made to the vehicle doors. Check all doors for indications of  
forced entry.  
Page 3  
128-6530  
3 of 10  
 
If the LED flashes 4 times...pause, 4 times...pause etc., then an intrusion  
attempt was made by impact or a strong vibration that the shock sensor  
detected. Check the vehicle for possible damage to the glass or body panels.  
NOTE: The LED intrusion warning indications are stored in the system's  
memory and will be erased when the ignition switch is turned on.  
VALET/OVERRIDE SWITCH:  
The valet switch allows you to temporarily bypass all alarm functions,  
eliminating the need to hand your transmitter to parking attendants or garage  
mechanics. When the system is in valet mode, all alarm functions are  
bypassed, however the remote panic feature and remote door locks will  
remain operational.  
1. Enter the vehicle, and turn the ignition key to the ON position.  
2. Press and hold the valet pushbutton switch until the dash mounted LED  
turns on solid. The system will remain in the valet mode.  
3. To return to normal operation, press and release the push button switch  
any time the ignition is on.  
NOTE: Always remember to return the vehicle to the valet OFF position. This  
will ensure that the vehicle remains protected at all times.  
MANUALLYOVERRIDINGYOUR SYSTEM:  
USING THE VALET/OVERRIDE SWITCH:  
Your Security system can be disarmed without the use of the OEM transmitter.  
This is necessary, since you will need the ability to operate your vehicle if the  
transmitter is lost or its battery fails. To Bypass the system:  
1. Open the vehicle door. The system will sound.  
2. Turn the ignition key to the ON position.  
3. Within 5 seconds, press and release the valet pushbutton switch.  
The system will stop sounding and enter the (by-passed) mode. You can now  
start and operate the vehicle normally.  
Typically this override mode is used only if the Factory (OEM) transmitter has  
become inoperative.  
Page 4  
128-6530  
4 of 10  
 
ELIMINATING/RETURNING THE NORMALARM/DISARM CHIRPS  
You can selectively eliminate the normal arm & disarm chirps using the valet/  
override switch, following these steps.  
1) Turn the ignition key ON the OFF.  
2) Within 10 seconds of turning the ignition key OFF, press and release the  
valet/override switch 3 times.  
3) If, before step 1,the chirps were ON, then you will hear 2 short chirps,  
which indicates the chirps are turned OFF.  
4) If, before step 1, the chirps were OFF. then you will hear 1 short chirp,  
which indicates the chirps are turned ON.  
5) Whenever the system's power has been disconnected, the chirps will be  
ON when power is reconnected.  
CA-310  
SYSTEM FUNCTIONS AT A GLANCE  
ALARM DASH LED INDICATORS  
RAPID FLASHING  
SLOW FLASHING  
OFF  
=
=
=
=
=
=
=
PASSIVEARMING  
ARMED  
DISARMED  
ON SOLID  
VALETMODE  
4 FLASH...PAUSE  
3 FLASH...PAUSE  
2 FLASH...PAUSE  
INTRUSION SHOCK SENSOR  
INTRUSION DOOR  
INTRUSION HOOD OR TRUNK  
ALARM SIREN CHIRP INDICATION  
1 CHIRP*  
=
=
=
=
=
ARM  
DISARMED  
ARMING WITH ENTRY POINT OPENED  
DISARM AFTER INTRUSION  
ALARM TRIGGERED  
2 CHIRPS*  
3 CHIRPS  
4 CHIRPS  
CONTINUOUS  
ALARM PARKING LAMP INDICATIONS  
1 FLASH  
2 FLASH  
3 FLASH  
CONTINUOUS FLASH  
=
=
=
=
ARM  
DISARM  
DISARM AFTER INTRUSION  
TRIGGERED  
Page 5  
128-6530  
5 of 10  
 
Code Systems, Inc. Limited Lifetime Warranty  
Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE  
vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as  
provided below) should this Product under normal use and conditions, be proven defective in material  
or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY  
INSTALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts  
directly related to repairs of the defect(s).  
Switches, indicator lights, and transmitter cases are similarly warranted to the original  
purchaser for a period of one (1) year from the date of purchase of the Product.  
CODE accessories, sold separately, are covered by the applicable warranty accompany-  
ing the accessory.  
This warranty is non-transferable, non-assignable and is voided when: (1) the Product is  
removed from the vehicle in which it was originally installed; or (2) the vehicle in which the Product  
was originally installed is transferred to another party.  
This warranty does not apply to any product damaged by accident, physical or electrical  
abuse, improper installation, alteration, or use contrary to its intended function, fire, flood, or other  
natural acts.  
In order for the Product to be repaired or replaced under the terms of this warranty, the  
defective Product must be returned to an authorized CODE dealer and accompanied by a copy of the  
retail sales receipt. The date of purchase and year, make and model of the vehicle in which the  
Product was originally installed must be clearly indicated on the sales receipt.  
This warranty is exclusive and CODE MAKES NO OTHER WARRANTIES EXPRESSED  
OR IMPLIED. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MER-  
CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE  
DURATION OF THIS WRITTEN WARRANTY. IN NO CASE SHALL CODE BE LIABLE FOR ANY  
CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WAR-  
RANTY, EXPRESS OR IMPLIED, WHATSOEVER.  
CODE does not warrant that the Product cannot be compromised or circumvented. THE EXTENT OF  
CODE’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT  
PROVIDED ABOVE AND, IN NO EVENT SHALL CODE’S LIABILITY EXCEED THE PURCHASE  
PRICE PAID BY THE ORIGINAL PURCHASER OF THE PRODUCT WITHOUT INSTALLATION  
LABOR.  
Some states do not allow the exclusion or limitation of incidental or consequential dam-  
ages, so the above limitation may not apply to you. This warranty gives you specific legal rights and  
you may also have other rights which vary from state to state  
128-6530  
6 of 10  
 
CODE-SYSTEM, INC. Theft Protection Program  
The Theft Protection Program is designed to provide the retail purchaser of a  
security system provided by CODE-ALARM, INC. (“CODE”) an additional  
benefit, at no additional cost to the purchaser, should their vehicle be stolen  
while protected by a CODE-ALARM security system. While CODE has created  
this program as a way of showing appreciation to its customers, CODE RE-  
SERVES THE RIGHT TO UNILATERALLY CHANGE, ALTER, MODIFY, OR  
DISCONTINUE ALL OR PART OF THIS THEFT PROTECTION PROGRAM  
WITHOUT PRIOR NOTICE. THIS THEFT PROTECTION PROGRAM IS NOTAN  
INSURANCE POLICY AND SHOULD NOT REPLACE AN AUTOMOBILE OR  
HOMEOWNERS INSURANCE POLICY. THIS THEFT PROTECTION PROGRAM  
DOES NOT COVER LOSSESARISING FROM THE THEFT OF ITEMS WITHIN  
THE AUTOMOBILE OR ANY DAMAGES ARISING FROM, RELEATED TO, AND/  
OR INCIDENTAL OR A CONSEQUENCE OF A VEHICLE THEFT EXCEPT AS  
SPECIFICALLY DELINEATED BELOW.  
128-6530  
7 of 10  
 
Plan duration: 3 Years from the date of installation.  
Plan amount: Maximum allowable value equal to insurance deductible or up to  
$2,500 whichever is less.  
Conditions of the Theft Protection Program:  
1. The Theft Protection Program is non-transferable and non-assignable.  
2. The system must be installed by an authorized CODE dealer.  
3. Vehicle must be less than three (3) model years old at the time of installation.  
4. The security system must have been fully armed at the time of the vehicle theft.  
5. The vehicle in which the system is installed must be insured for theft by a licensed  
insurance underwriter in the state in which the vehicle is registered.  
Terms of payment:  
1. The vehicle must first be considered a total loss due to theft by your insurance  
company.  
2. Your insurance company has settled all claims arising from this theft and there are  
no other pending legal actions as a result of this theft.  
How to file a request for payment:  
If the above conditions are met, make your request for payment by submitting the  
following to CODE. The request for payment must be received by CODE no later than  
sixty (60) days after the vehicle is reported stolen.  
1. Copy of the retail sales receipt for the purchase of the security system, clearing  
showing the model of system purchased and the year, make and model of the  
vehicle in which the system was installed.  
2. A copy of the police report for the stolen vehicle.  
3. A copy of the paid insurance claim and reimbursement check from the insurance  
company.  
*The Theft Protection Program is not available in all states please contact  
dealer for more information.  
CODE SYSTEMS, INC.  
1-800-421-3209  
128-6530  
8 of 10  
 

Coleman Tent 2000010387 User Manual
Compaq Personal Computer 228399 373 User Manual
Cooper Lighting Indoor Furnishings CM2B User Manual
Craftsman Boat Trailer 0220 User Manual
Danby Range DR3009WGLP User Manual
Delkin Devices Indoor Fireplace EI 25 1 User Manual
Euro Pro Carpet Cleaner SC926H User Manual
Fisher Paykel Washer GW712 User Manual
GE Monogram Ventilation Hood ZV750 User Manual
Generac Power Systems Switch 004945 1 User Manual