Behringer Stereo Amplifier BO100 User Manual

BLUES OVERDRIVE BO100  
Thank you for showing your confidence in us by purchasing the BEHRINGER BLUES  
OVERDRIVE BO100. This classic effects pedal is specifically designed to deliver the  
warm and emotive distortion usually known from 30-year-old classic tube amps. Thanks  
to its high-performance features you will achieve the tone of a vintage and bluesy tube  
amp that captures every nuance of your playing. And if you feel like it, you can rock out  
with full-blast distortion.  
1. CONTROLS  
Top view  
The LEVEL control adjusts the output level.  
The TONE control adds tube-like warmth to the overall sound.  
Use the GAIN control to adjust the amount of overdrive.  
The ON/BATT LED illuminates when the effect is activated. It also serves as a  
battery level indicator.  
Use the footswitch to activate/deactivate the effect.  
Use this 1/4" TS IN connector to plug in the instrument cable.  
The 1/4" TS OUT connector sends the signal to your amp.  
Use the DC IN connection to plug in a 9 V power supply (not included).  
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or  
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be  
careful not to scratch the unit.  
+
The BO100 has no on/off switch. As soon as you insert the jack into the  
IN connector, the BO100 begins running. When not using the BO100,  
remove the jack from the IN connector. This extends the life of the  
battery.  
The SERIAL NUMBER is located at the bottom.  
 

Acesonic Stereo System DGX 400 User Manual
Acu Rite Thermostat D1523 User Manual
ADC Power Supply DMPS 10CE User Manual
Agilent Technologies Computer Drive FS4100 User Manual
Alpine Car Stereo System CDA 9856 User Manual
Aluratek Computer Drive AHDUS350 User Manual
Atmel Network Card ATA6602 User Manual
Audiovox Remote Starter 128 8121 User Manual
Axiom Audio Speaker VP150 User Manual
BC Speakers Portable Speaker WG800 User Manual