Audiovox Automobile Alarm APS 25C User Manual

Model APS-25C  
Owner's Manual  
3 Button Remote Security System  
Congratulations! Your purchase of this state-of-the-art security system  
expresses a deep concern for the security of your vehicle, its contents,  
andpassengers. Tofullyappreciatethemanyfunctionsandsafeguards  
incorporated in this system, please spend a few minutes reading this  
manual.Youmayfindunexpectedfeaturesthatcouldmeanthedifference  
betweenprotectedandfullyprotected”.  
FEATURES :  
2 Three Button Programmable Code Hopping RF Transmitters  
Three Channel Receiver ( capable of accepting 4 transmitters )  
Code Learning  
Remote Panic in all modes  
Protected Valet  
7 Function LED - Arm / Disarm / Zones 1, 2, & 3 / Valet / Arming  
Intrusion Alert with Memory  
Audible Arm / Disarm / Defective Zone / Tamper Confirmation  
Instant Siren Activation  
Starter Disable  
True Last Door Arming ( hardwire only )  
Defective Zone By - Pass  
Hardwire or Voltage Sense Selectable  
Active or Passive Arming Selectable  
User Programmable Permanent Chirp Delete  
6 Tone Multi-Tone Siren  
Additional Negative Trigger Input  
RF Inhibit with Ignition On  
Parking Light Flasher  
Plug In Dual Stage Shock Sensor  
OPTIONS :  
Remote Trunk Release  
Remote Keyless Entry  
Multiple Vehicle Capable  
Remote Starter  
Remote Power Window Roll Up  
Remote Garage Door Interface  
128-8807  
1 of 5  
 
4. Whenever the system is triggered, the vehicle's parking lights will flash for the 30 second  
alarm cycle, attracting added visual attention to the vehicle.  
5. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief should  
choose to ignore the siren, the vehicle can not be started.  
DISARMINGTHESYSTEM:  
1. As you approach the vehicle, press and release the Unlock button on the keychain  
transmitter.  
CAUTION! Excessive pressure on the transmitter buttons will damage the internal components  
on the circuit board. All that is required is a light push to the button.  
2. The siren will "chirp" 2 times and the vehicle's parking lamps will flash two times.  
3A. ACTIVE: The dash mounted LED will turn off, and remain off until the system is re-armed.  
3B. PASSIVE: Never attempt to disarm the system from a distance that prevents you from  
opening a door within 30 seconds. Since the system is programmed for passive arming,  
it will begin to re-arm until a door is opened. Opening the door will suspend the passive  
arming cycle.  
INTRUSIONWARNINGSIGNALS:  
The system will inform you if an intrusion attempt has occurred while you were away from  
the vehicle. If an intrusion attempt has occurred, the siren will "chirp" 4 times when disarming  
the system.  
The vehicle's parking lights will also flash 3 times to indicate an intrusion has occurred. Enter  
the vehicle and observe the dash mounted LED for further information.  
1. If the LED is flashing one time... pause...one time... etc., then an intrusion attempt was  
made to a light activated entry point, or the shock sensor was activated.  
2. If the LED is flashing two times...pause...two times...etc., then an intrusion attempt was  
made to the hood, trunk, or an optional sensor that has been connected to zone 2.  
3. If the LED is flashing three times...pause...three times...etc., then an intrusion attempt was  
made through one of the vehicle's doors.  
These intrusion warning indicators are stored in the system's memory and will only be erased  
from memory when the ignition key is turned on.  
Push-Button LED Valet / SYSTEM OVERRIDE Switch:  
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need  
to hand your transmitter to parking attendants or garage mechanics. When the system is in  
valet mode, all alarm functions are bypassed, however, the remote panic feature and remote  
door locks (optional) will remain operational. To use the valet mode;  
1. Enter the vehicle and turn the ignition key to the "on" position.  
2. Press and hold the LED valet push-button switch for 5 seconds until the LED turns  
on solid. The LED will remain on as long as the system is in the valet mode.  
3. To return to normal operation, with the ignition switch on, press and release the LED valet  
push-button switch one time. The LED will turn off indicating the unit has been returned  
to the normal mode of operation.  
In the event you lose your keychain transmitter, or if the transmitter fails to disarm the system,  
the valet switch can be used as a system override switch. Open the car door (the alarm  
Page 3  
128-8807  
3 of 5  
 
will sound). Turn the ignition key on, and press and hold the LED valet switch on. The  
alarm will stop sounding, and the vehicle can now be started.  
NOTE: Always remember to exit Valet Mode to ensure that the vehicle remains protected at  
all times.  
ELIMINATING THE ARM / DISARM CHIRPS:  
The normal arming and disarming confirmation "chirps" can easily be turned on and off using  
the valet push-button switch. To do this...  
1. Turn the ignition key on, and then off.  
2. Within 10 seconds of turning the ignition key off, press and release the LED valet  
push-button switch three times.  
3a. If, before proceeding with step 2, the chirps were on, then you will hear 2 chirps to indicate  
that the chirps have been turned off.  
3b. If, before proceeding with step 2, the chirps were off, then you will hear 1 chirp to indicate  
that the chirps have been turned on.  
Note: Whenever the chirps are by-passed, the 3 chirp defect and 4 chirp intrusion indicator  
will always operate. This feature will always warn you if there is a defective sensor  
during the arming sequence or if the vehicle had been tampered with in your absence,  
even if the normal arming and disarming chirps have been turn off.  
REMOTEPANICOPERATION:  
The Lock and Unlock buttons on your keychain transmitter also functions as a "panic" switch  
for instant activation of the alarm in emergency situations. To use the remote panic switch;  
1. Press and hold the arming button on the keychain transmitter for 3 seconds or more.  
The alarm will immediately sound.  
2. To stop the alarm, press and release the Trunk/Key button on the keychain transmitter.  
If the button is not pressed, the alarm will automatically stop after 30 seconds.  
CAUTION! Excessive pressure on the transmitter buttons will damage the internal  
components on the circuit board. All that is required is a light push to the button.  
TRUNKRELEASE:  
This security system has an additional feature that can be wired to a number of different  
optional accessories. Some of the more common uses for this "channel" are:  
Remote Trunk Release - available for any vehicle with factory installed electronic  
push-button trunk release.  
Remote Car Starter - available for most automatic transmission, fuel injected vehicles.  
Remote Window Roll Up - available for most vehicles equipped with power windows.  
To activate the optional accessory:  
Press and hold the Trunk/Key button on the keychain transmitter for approximately  
3 seconds. If the system has been programmed differently by your installation center,  
this output may be accessed by pressing buttons 1&2 simultaneously for 3 seconds.  
NOTE: This feature will not operate when the vehicle's ignition key is turned "ON".  
Page 4  
128-8807  
4 of 5  
 
APS-25C  
SYSTEM FUNCTIONS AT A GLANCE  
DASH LED INDICATORS  
RAPID FLASHING..............................................PASSIVE ARMING  
SLOW FLASHING .............................................ARMED  
OFF ....................................................................DISARMED  
ON - SOLID........................................................VALET MODE  
3 FLASH ... PAUSE ...........................................INTRUSION ZONE 3  
2 FLASH ... PAUSE ...........................................INTRUSION ZONE 2  
**1 FLASH ... PAUSE ...........................................INTRUSION ZONE 1  
SIREN CHIRP INDICATORS  
* 1 CHIRP ............................................................ ARM  
* 2 CHIRPS .......................................................... DISARM  
3 CHIRPS ......................................................... ARM / ZONE ACTIVE  
4 CHIRPS ......................................................... DISARM / INTRUSION  
PARKING LAMPS (Optional)  
1 FLASH ............................................................ARM  
2 FLASH ............................................................DISARM  
3 FLASH ............................................................DISARM / INTRUSION  
** Where applicable.  
* These chirps are optional and may be disengaged.  
Your System Has These Features Activated:  
Starter Cut-out  
Door Lock Interface  
Shock Detector  
Motion Detector  
Hardwire  
Optional Channel 2 Device  
© 2010 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788  
128-8807  
Page 5  
128-8807  
5 of 5  
 

ADS Technologies Switch USBH 2004 User Manual
Aiphone Power Supply SKK 620B User Manual
Aiphone Speaker System LEM 1L User Manual
Airlink101 Switch AKVM 2A User Manual
AKG Acoustics Headphones C 420 User Manual
Alpine Automobile Alarm SEC 8063 User Manual
American Standard Bathroom Aids 255102 User Manual
Audiovox Speaker VLS 105 User Manual
Beko Dishwasher DWD5414 User Manual
Eureka Tents Tent Scenic Pass XT User Manual